]> jspc29.x-matter.uni-frankfurt.de Git - trbnet.git/shortlog
trbnet.git
2020-06-02 Jan Michelmove old files to sub directory
2020-02-26 Ingo Froehlichsmall changes to make pexor compile again
2019-08-30 Jan Michelapply patches bei Thomas Geßler - syntax fixes
2019-04-29 Adrian WeberGbE Fifos for ECP5. Fifos > 16k missing
2019-04-25 Jan Michelupdate SCI reader for ECP5
2019-04-25 Jan MichelUpdate ECP5 serdes files
2019-04-08 Jan Micheladd old SPI interface for designs not compatible with...
2019-01-31 Jan Micheladditional SPI features for non-standard interfaces
2019-01-16 Jan Michelfix inclusion of I2C instead of 1-wire
2018-11-26 Jan MichelUpdate endpoint with I2C sensor option
2018-11-22 Jan Micheladd I2C files from MB
2018-11-09 Adrian WeberMinEvSize=0; Adding Reg 0x7110 to 0x7114 to CTS
2018-10-31 Jan Micheladd record for trbnet data paths
2018-10-31 Jan Michelenable RX Fifo on uplink for sync media interface
2018-07-16 Jan Micheladd option to discard events if they are below a certai...
2018-07-12 Jan Micheladd counter for code violations
2018-07-10 Your NameGK: fixed oversized subevents crashes
2018-06-14 Jan Michelchange asynchronous detection of reference time edges
2018-06-14 Jan Michelremove some debug signals for better timing
2018-05-30 Your Namegk:trigger type taken from FEE stream instead of CTS_RE...
2018-04-25 Your Namegk: updated EB address selection
2018-04-19 Jan Michelset unconnected registers to 0
2018-04-19 Jan Michelless warnings in Diamond
2018-04-19 Jan Michelfix ipu counter register
2018-03-28 Jan Micheladd few more registers to sync media interface
2018-03-27 Jan Micheladd reset counter to hub
2018-03-27 Jan Michelimprove Serdes reset routine
2018-03-09 Jan Michelupdate reset procedure in media interface sync and hub
2018-02-02 Jan MichelRemove got-link-ready detection for sync interface...
2018-01-31 Jan Michelupdate sync media interface and longer network reset
2018-01-22 Jan Michelsome more cleanup
2018-01-22 Jan Michelremove unused ports
2018-01-19 Jan Michelchange memories of gbe_ecp2m back to ecp2m versions
2017-12-22 Jan Micheladd "first idle after data" signal in tx_control
2017-12-21 Jan MichelUpdate .gitignore
2017-12-15 Jan MichelRevert "gbe with configurable ip address"
2017-12-15 Jan MichelRevert "gk: fixed reversed dhcp ip address"
2017-12-15 Jan MichelRevert "gk: updated link status"
2017-12-15 Jan MichelRevert "add missing end if"
2017-11-29 Jan Micheladd missing end if fixedIP
2017-11-28 Your Namegk: updated link status
2017-11-24 Your Namegk: fixed reversed dhcp ip address
2017-11-17 Your Namegbe with configurable ip address
2017-11-14 Jan Micheladd temperature to outputs of hub streaming
2017-11-14 Jan Michelfix large Fifos for ECP5
2017-11-09 Jan Michelfix asserts for buffer sizes
2017-11-09 Jan Michelclean-up in media interfaces
2017-09-26 Jan MichelAllow hub with less ports than 2
2017-09-22 Jan MichelSome default values for unused signals to reduce number...
2017-09-18 Your Namegbe with forwarder
2017-09-18 Your Namegbe with forwarder
2017-08-17 Jan MichelRemove clock renaming to clk_200 in media interfaces
2017-08-17 Jan MichelFix IPU handler - remove Latch
2017-08-11 Jan MichelSync media interface uses RXI clock on receiver side.
2017-08-11 Jan MichelAdd better sync of media interface control signals...
2017-07-25 Jan MichelUpdate few bits of sync media interface reset handling
2017-07-25 Jan MichelUpdate ECP3 full quad to AC coupling
2017-06-29 Your Nameupdate
2017-05-23 Your Nameupdated trigger type
2017-04-13 Jan MichelFEE loads trigger number with first event after reset...
2017-01-24 Jan MichelNew fifos for trbnet update
2016-10-07 Jan Micheladded records for API connection
2016-08-25 Jan Michelupdates to sync media interface for dirich modules
2016-08-22 Your Nameupdate
2016-08-10 Your Namekiller ping added
2016-07-11 Jan MichelDisconnect some debug signals for better timing
2016-07-08 Your Namegbe update
2016-07-06 Jan MichelUpdate to ecp5 media interface
2016-05-27 Jan MichelUpdate to UART, fix for wrong bit start signals
2016-03-22 Jan MichelAdding some logic to bus_handler_record to cope with...
2016-03-21 Jan Micheladding testbench for input_to_trigger_logic
2016-03-18 Jan MichelAdditional temperature output for hub
2016-03-18 Jan Michelupdating sync media interfaces: no more high-speed...
2016-03-14 Cahitsyntax correction
2016-01-11 Jan Michelchanging ecp5 fifo name to ecp3 for compatibility
2016-01-07 Jan Michelpreparation of ecp5 media interface and machxo3 fifo
2016-01-04 Jan MichelAdding missing Fifos for ECP5
2015-12-16 Jan MichelClean-up of endpoint ports and adding a new register...
2015-12-15 Jan MichelAdding new port to endpoint for external slow control...
2015-12-09 Jan MichelAdding a testbench for onewire entity
2015-11-27 Jan MichelMoving MAC generation to top level gbe_wrapper
2015-11-25 Jan MichelFixing register read issue in GbE
2015-11-20 Jan Michelfixing slow control register feedback signals
2015-11-20 local accountupdate
2015-11-03 Jan MichelAdding uid as output to timers record.
2015-10-27 Jan MichelAdding debugging register for onewire (0x9).
2015-10-20 Jan Michelchanging handler_ipu as work-around of Synplify K2015 bug
2015-10-16 Jan MichelSeveral changes to synchronous media interfaces
2015-10-16 Jan MichelNew media interface for mixed master/slave operation
2015-10-15 Jan Michelchanging gbe_wrapper to use sctrl records
2015-10-15 local accountupdate
2015-10-13 local accountgbe serdes config file added
2015-10-13 local accountremoved rtanscript
2015-10-13 local accountupdated gbe
2015-10-13 Jan Michelnew register handler with records
2015-08-10 Jan Michelall channels working on hub
2015-08-06 CahitMerge branch 'master' of jspc29.x-matter.uni-frankfurt...
2015-08-06 Cahitieee standard packages should be used
2015-08-06 Jan Michelupdate
2015-08-06 Jan Michelupdate
next